SPF 50 Sunscreen PA+++

STEP 1
Apply as the final step of your morning routine — after all serums and moisturisers have fully absorbed.

STEP 2
Apply generously. Use approximately two full finger lengths of product for your face and neck — most people apply only a quarter to half of what's needed, which significantly reduces the actual protection level below SPF 50.

STEP 3
Gently massage over the face and neck until fully absorbed. Allow 2-3 minutes to settle before applying makeup, if used.

When to Use: Every morning, without exception — including cloudy days and days spent mostly indoors. Reapply every 2 hours if outdoors during peak UV hours (10am-3pm).

Common mistake to avoid: Relying on SPF in foundation or makeup as your primary sun protection. These products are applied in far smaller quantities than what's needed to deliver their stated SPF level. Always apply a dedicated sunscreen first, then makeup on top if desired.

Tip: This is the mandatory final step for every SkinFactor routine, regardless of which actives you're using. Whether your morning routine includes Vitamin C Serum, Niacinamide Serum, or nothing else at all, this is the one product that should never be skipped.

SkinFactor's SPF 50 Sunscreen PA+++ is the mandatory final morning step for every SkinFactor routine — the product that determines whether every active ingredient applied before it delivers its full result or works against an uphill gradient of daily UV damage. In Pakistan's UV index of 8 to 11 for most of the year, a well-formulated daily sunscreen is not a skincare preference. It is the difference between a routine that works and one that does not.

Why this sunscreen works where most fail on Pakistani skin:

The most common reason Pakistanis skip sunscreen is texture. Pure mineral sunscreens — formulated with only Zinc Oxide and Titanium Dioxide — provide excellent broad-spectrum protection but leave a visible white cast on South Asian skin tones and feel heavy in Pakistan's heat and humidity. Most people try them once and do not buy again.

SkinFactor's SPF 50 is a hybrid formula — it combines mineral UV filters (Microfine Zinc Oxide and Microfine Titanium Dioxide) with chemical UV filters (Ethylhexyl Methoxycinnamate and Octyl Salicylate). This hybrid approach is what produces the lightweight, no-white-cast finish that makes it wearable daily in Pakistan's conditions. The microfine mineral particles minimise the white cast typical of mineral sunscreens. The chemical filter component reduces the volume of mineral filters needed, lightening the texture while maintaining SPF 50 broad-spectrum protection. Reviews consistently confirm: no white cast, no greasiness, absorbs quickly.

What SPF 50 PA+++ actually means:

SPF 50 measures UVB protection — SPF 50 blocks approximately 98% of UVB radiation. PA+++ measures UVA protection — PA+++ indicates strong UVA blocking. Both matter. UVB burns and causes skin cancer risk. UVA penetrates deeper into the skin, degrades collagen, and drives the pigmentation and premature ageing that Pakistan's sustained high UV exposure produces over years of unprotected daily exposure.

Active ingredients beyond sun protection:

Niacinamide — controls sebum production and reduces the oiliness that Pakistan's heat amplifies throughout the day. For oily skin already using the Niacinamide Serum, this adds an additional daily dose through the SPF step without requiring an additional application. Also supports the skin barrier and reduces redness during sustained sun exposure.

Hyaluronic Acid

— maintains surface hydration throughout the day. In air-conditioned environments and high heat conditions that dehydrate skin continuously, HA in the sunscreen provides sustained hydration under the protective film.

Vitamin E

— an antioxidant that works synergistically with the sunscreen's UV filters, providing additional free radical neutralisation for UV radiation that reaches the skin past the SPF film.

Why SPF is non-negotiable with active ingredients:

Every active ingredient in SkinFactor's range either increases UV sensitivity or works against a baseline of daily UV damage in Pakistan's climate. Salicylic acid, glycolic acid, and kojic acid all increase UV sensitivity. Vitamin C, niacinamide, and kojic acid are all working to fade dark spots that UV triggers are simultaneously creating daily. Using any active without daily SPF 50 means the active is compensating for ongoing damage rather than making forward progress. SPF is the step that makes every other product in your routine worth using.

How to use:

Apply generously as the final morning skincare step — after all serums and moisturisers have absorbed. Apply to face and neck and allow to settle before applying makeup if used. Reapply every two hours if outdoors during Pakistan's peak UV hours of 10am to 3pm. Do not rely on SPF in foundation or makeup as the primary sun protection — these are applied in insufficient quantities to deliver the stated SPF level.

Pairs with every product in the SkinFactor range as the mandatory morning final step. See how it fits into the complete routine in the acne routine guide, the anti-pigmentation routine, and the vitamin C morning routine.

📍 Nationwide Delivery (Pakistan)

• Major Cities: 2–3 working days
• Other Cities & Towns: 3–5 working days
• Delivery may take 3–6 days during sale periods.
• ⏳ Orders placed on weekends or public holidays are processed the next working day.

📦 Order Processing Time:

• Orders are dispatched within 24 hours after confirmation.

🔁 Order Cancellation & Refund

• If your order has not yet been processed, we will be able to cancel it and issue a full refund.
• Shipped orders cannot be cancelled but can be returned as per our return policy.
• Refunds are issued to the original payment method within 5–7 business days.